How high is the material quality of the beacon lights, and the buildings need to be installed?
The appearance of beacon lights, like China Heliport Final Approach Light,Airport Crossbar Light suppliers,Cheap Heliport Touchdown Light,taxiway alarm light suppliers,China Heliport Beacon Light,Cheap Heliport Aiming Light,runway middleline light, should meet the following requirements: .
The surface coating should be uniform and should not be blistered, cracked, scratched, peeled off and worn, the lens should be clear, transparent, free from impurities, scratches and contamination, and components and parts should not have obvious dents, scratches , cracks, deformation and pollution, etc., metal parts and components should not be rusted, and fasteners should not be loose.
Material quality requirements for beacon lights: .
1. The lens material of the beacon light should be a high-transmittance material with anti-ultraviolet rays, and the photosensitive cover of the daylight switch used in the beacon light should be a material of high light-transmittance with anti-ultraviolet rays.
2. For the watertight beacon light parts used for beacon lights, the fasteners should be made of corrosion-resistant materials.
3. The cables used for navigation lights should be rubber insulated marine cables and copper conductors.
4. The base material of the beacon light should be made of materials with sufficient weather resistance and structural strength requirements.
5. The circuit components of the beacon light should use industrial-grade or better components, and the surface should be coated with a "three-proof" coating of moisture-proof, salt-fog, and mildew-proof.
Aviation obstruction lights are special lamps widely used in the aviation field. In order to avoid the impact of super high-rise buildings on flying aircraft, it is generally necessary to install aviation obstruction lights on high-rise buildings to achieve obvious warning effects. Tall buildings require the installation of aviation obstruction lights.
Aviation obstruction lights refer to the obstruction lights installed on fixed buildings, structures, airport moving objects and other obstacles. The installed obstruction light fixtures are also not the same: .
1. If the top of the object is more than 45 meters above the surrounding ground, an obstacle light must be installed in the middle layer for safety reasons, and the distance between the middle layer must be no more than 45 meters and as equal as possible, and more than 100 meters in the city. For buildings with super high aviation lights, it is especially necessary to consider adding obstacle lights on the middle floor, but when adding obstacle lights, try to avoid the discomfort of surrounding residents, and it is best to only see scattered light from the ground.
2. For 105-meter-high objects, facilities or cable towers, roof towers, etc., medium-intensity type-A obstacle lights should be set at the top of them, and flash white, and red medium-intensity type-B obstacles should be set at the lower part of the layer. lamp.
3. For 105-meter-high objects, facilities or cable towers, roof towers, etc., medium-intensity A-type obstacle lights should be set at the top of them, and flash white, and red medium-intensity B-type obstacles should be set on the lower part of the layer. lamp.