Wire connection of aircraft warning lights
In many cases, the aviation obstruction lights purchased can work normally and emit light when tested at the factory, but they cannot emit light normally or emit light abnormally when the project is installed and debugged on site.
The production, debugging and sales of aviation obstruction lights have a series of formal standard procedures. The lamps have been aging and tested for a long time before leaving the factory. According to statistics, the reasons for the obstruction lights not working normally in the project are basically due to on-site construction. The personnel failed to perform the normal wiring of the luminaire in accordance with the installation instructions of the luminaire. In some projects, if the local voltage is too high, the obstruction lights will be burned out directly. Therefore, before proceeding with the lamp installation operation, please read the lamp installation instruction manual to carry out the correct lamp installation work.
Aviation obstruction light signal line with flashing light cable has four cores, brown and black are power lines, gray (blue) line is signal line, and yellow-green is grounding line (PE); if the lamp needs to flash continuously, then After connecting all the wires of the same color in parallel, connect the brown and black wires to the power supply.
